Котел твердотопливный отличается тем, что подача fuel in it is not automated. For this reason, this type of device refers to a batch device. The heat carrier in them is heated only during the combustion of each new portion of fuel. To somehow smooth out fluctuations in temperature, it is necessary to constantly load firewood or coal.
The density and mass of building materialshigher, the greater their heat capacity. Everyone noticed that in buildings with thick stone walls, it's fresh in summer, and in winter it's warm. Modern technologies in construction go in the opposite direction. The constructions become lighter, the use of materials with low density increases. For example, a house erected on a frame-panel or wireframe technology, is able to provide thermal comfort only on condition that the heating and air-conditioning systems will work continuously. This structure has a minimum heat capacity.
If the house uses a solid fuel boiler,then to increase the comfort you can use a concrete screed of the warm floor as a battery. This is due to the following reasons. The design of the floor with water heating contains a rather impressive layer of concrete. Such a floor can be called a kind of analogue of the Russian furnace in modern construction. The warm floor as a result becomes an accumulating heater, which slows down the temperature fluctuations and increases the comfort of the whole system, which is based on the solid fuel boiler.
В помещении, снабженном теплым полом, можно Provide thermal comfort at a temperature a couple of degrees lower than with traditional radiators, so you can save fuel.
In a house where as the main source of heatA solid fuel boiler is used, reviews about which are mostly positive, it is recommended to arrange a warm floor in all rooms. If you include radiators in separate rooms, then a small thermal inertia will cause the rooms to heat up more quickly and cool down. Temperature fluctuations in rooms with warm floors between the furnaces will be minimal.