Давным-давно человечество изобрело такую вещь, like plastic gutters. They are widely used in private courtyards, just on the streets of large and small cities, in areas of enterprises and factories. They have many varieties and interpretations, but their main function is the same - collecting rainwater or melt water, as well as other liquid waste that is on the sidewalks or drains from the roof. Often plastic drainpipes are connected to a drainpipe, through which all the liquid and melted snow enter them.
As mentioned above, this findHumanity has many varieties. Depending on the location, the type of water inlet, its size, weight and endurance are chosen. After all, some of the lattices are mounted in private courtyards and connected to a drainpipe, others are located directly on the roadway, and others are located on sidewalks and avenues. And also they are surely mounted near factories and plants where it is necessary to adhere strictly to safety regulations.
All plastic drain pipes are made ofadapted material that can withstand the weight and dynamics of the car passing through it. They are divided into four categories, which differ in class load, total weight, size and other parameters. For example, the plastic inlet 300x300 is suitable for the AC load class and has a mass of 2.5 kilograms. This is one of the most common containers, so it can be found both in the city and in a private courtyard. It is followed by tanks with parameters 400 x 400 and 550 x 550, with a weight of 3.5 kg and 7 kg, respectively. Most often they can be seen in the factory area.
Plastic water inlets are always connected tosewer channel. Water, falling into them, first located in a small container, which is located under the main grid, and then displayed in common pipes. Often, along with the liquid, there is street garbage that can be piled on the walls of the container and rot. These tanks are equipped with special filters, and the employees of the housing department will certainly have to clean them. Plastic drainage basins, which are located in private possessions, work on the same principle, and the owners themselves must follow their cleanliness.
Важно также, чтобы решетка, которая является a kind of "cover" of such a system, tightly fixed in place. There should not be locks or clips, it is simply necessary that the edges of the protective part and the tank fit snugly together. If you take into account this condition, any plastic inlet will last for a very long time. The price for it will depend on the size and characteristics of the material, but in any case, this indicator will remain acceptable and affordable (the cost varies from 10-100 dollars).
The foundations of irrigation were laid by such an ancientpeople like the Sumerians. Those people understood that it is important not only to competently supply water to the city, but also to “pull out” everything superfluous from there. Therefore, when choosing plastic drainage basins, one should pay attention to their quality, shelf life and material that underlies the whole structure.
