To tie a beautiful collar, in fact,is quite difficult, and it is unlikely to avoid this work, because the higher the knitter's skill, the more a variety of models, including with different collars, can be linked. Knitting collars with knitting needles, first of all, turn-down, it is better to carry out separately, and then gently sew to the collar. Turn-down collars come in a variety of shapes and shapes. The most common models are a collar and a turn-down collar with rounded or pointed tips. Let's consider ways of knitting these models in order.
Knitted collar knit with thin knitting needlesfrom yarn into two strands. Pick the right amount of loops, which depends on the width of the gate, and knit an elastic band for about ten rows. Then, at the same time, from both ends of the crochet, nine loops of four loops and three times three loops are not sequentially sewn together. After that, all the remaining loops are closed at the same time. It is possible not to close the hinges, but to tie one row with an auxiliary thread. Sewing the collar to the neck, the auxiliary row is gradually dismissed, and the open hinges of the extreme row of the collar are gently sewed with the ketlevochnym seam to the knitted fabric.
Knitting collars with knitting needlesit is better to make the tips also from the twin yarn. The size of the spokes is 2.5. Knitting starts from the outside of the collar. Collect the right amount of loops and knit with an elastic band. Simultaneously with the beginning of knitting, 26-30 loops are counted from each side. The 26th or 30th loop will be central at the same time: on each side of each face line, the loops are reduced, tying together two loops for the rear leg with facial knitting. Then knit until the required width of the collar is obtained. All the loops remaining on the spoke are closed at the same time, or done in the same way as described above.
Knitting collars with knitting needles with roundedthe tips, on the contrary, start from the inside of the collar. A necessary number of loops is typed on the auxiliary thread and one or two rows are sewn. After that, they pass to the main yarn of knitting and knit ten rows with the chosen pattern, after which, on both sides of each row, one loop is cut in seven steps.
In addition to turn-key, in knitted models very oftenthere are collar-struts, which are typical for sweaters, manicure and knitted jackets. Knit the collar-stand perform after the seams are stitched on the shoulder. On the neck, the required number of loops is typed on the circular thin needles and the four rows are tied with facial knitting. Then go to the main pattern for the collar (elastic, openwork, or face knitting). Collar-stand under the neck knit directly to the desired length. After that, all the loops are closed at the same time, performing a free elastic edge. If it is necessary to tie a collar lagging behind a neck or a collar-yoke, then, tying about five centimeters straight, begin to add loops at the same distance from each other along the entire length of the collar.
Knit on circular knitting needles is difficult and notvery comfortably. Therefore, often the collar-struts are performed with a seam from behind, or a buckle. Collars with a seam knit on two spokes separately, and then sew up to the neck. A stand-up collar with a fastener that can be rear, side, or front is also separately provided. To unfasten the fastener on both sides of the collar, the bar is laid with a string, or with a facial surface. On one side the straps are fastened with buttonholes. Counting the length of the collar, you need to add about two centimeters to the buckle, and, sewing the collar, put one part on the other for the width of the fastener. To avoid a thick and sloppy stitch, knitting starts on the auxiliary thread. Then open the hinges sewn to the neck.
Knitting collars with knitting needles is an opportunity to create a beautiful extra detail that will make the knitting model more stylish and original.
