If you are really a national craftsman, it's worthchoose work to your liking, even if your own car is only in the plans. Easy changes in the neighbor's car - and you can open your own workshop. Tuning UAZ with your own hands, such as a body lift or large wheels, will not only give the car a new look, but also make the vehicle more convenient to operate.
Now it is necessary to raise the body itself, but beforeit is necessary to release the battery from the terminals and wires, so as not to shorten. Under the car it is necessary to lay the supports and disconnect the mass that is next to the starter. To do this, you have to climb under the bottom. After this front of work is done, unscrew the nuts from the bolts. They should be 12, and you can use a jack to lift the body to the required height. For you it's the height of the stands.
Without touching native spacers, old boltspull out, now dispose of what was installed in the factory (the designers did not expect that you want to do tuning UAZ yourself), install new spacers, the bolts - in place. To do the work quickly, it is worthwhile to put the nut on the thread and then tighten it.
While the body of UAZ is raised, all equipmentreturn to the place. Well, if you do not have to lengthen. Sometimes there are situations when some of the wires become short. But it does not matter, they can easily be replaced.
Tuning salon UAZ does not require special works, ifonly slightly reduce the noise level. Rinse the doors with rubber gaskets, ceiling, floor and doors are covered with noise-absorbing material, replace the upholstery.
Do you like tuning UAZ?"Loaf" with their own hands poorly preserves the heat, so the car owners together start to insulate the "iron friends." Isopen or isophone for this type of car will not do: a bit thick. At bends and corners with them you torture yourself. Take a thin foam or a substrate under the laminate and press 2 layers of conventional decorated plywood. Part of the machine can be glued with a thin sealant.