How to beat off the spit correctly

Despite the fact that recently appearedNew modern mowers and trimmers, many still use the usual manual braids. After all, in order to simply remove the grass under the trees and along the fence, it is absolutely useless to spend money on newfangled funds. It will be enough and the simplest grandfather's braid on the handle. However, this tool also needs some care.

Over time, the blade becomes blunt, mowing becomesquite hard. Of course, you can sharpen his bar. But a sustainable result in this case is difficult to obtain. After an hour and a half of work, he again will require sharpening. Therefore, many gardeners and gardeners often have a question about how to recapture a scythe. The case is quite simple technically, but it is very long in time and requires accuracy. With the wrong approach, the tool can simply be spoiled. Therefore, usually in this case, refer to a specialist. However, if you are confident in your abilities, you can try to do it yourself.

First you need to prepare the tools.You will need an old file, a regular stump or a chump and a hammer. The handle is removed from the first tool and the part of the cloth adjacent to it is cut off so that five centimeters are left. The edge of the piece will need to grind off. Ultimately, he must take the profile of a semicircle. This is necessary in order to repel the braid and give the blade the desired shape. The heel of the hammer is grinded until it is completely flat. The usual tool can not be used.

So, how to beat off the braid? The prepared file slice is driven into the wood of the wood. To fix it better, you can use a nut. If desired, you can use a small anvil.

But in this case, you need a special hammer.Next, the blade is removed from the spit. To do this, knock out the mounting ring. Sometimes it is screwed on the nut. In this case, of course, the latter is unscrewed beforehand. Then a wedge is taken out, with the result that the simple structure is broken into pieces.

To understand how to beat off a braid professionally,need to look at her blade. Ultimately, it should have a small notch along the edge. For this, the corresponding file shape was attached. The blade is placed on the hammered file edge, absolutely horizontal and begin to gently tap on it with a hammer. Action area

it should not exceed two millimeters.For convenience, you can put a bar of the same size as the anvil under the opposite end of the blade. Experts advise: it is better to strike several times, but neatly than one, but strongly. It is necessary to beat, slightly pulling the hammer along with the metal towards you. From time to time it needs to be wetted. The result should be a thin and very sharp edge.

Thus, the blade is processed along its entire length.As a result, the edge does not work completely flat, such as, say, a knife. There are always small notches. In the end, something like a micropicka comes out that cuts grass very well. Thus, the answer to the question of how to correct a scythe is clear. The edge must not be simply repulsed, but drawn. On the reverse side, the desired groove is obtained. Everything must be done very carefully.

Next, the blade is put back on the stalk, a wedge is inserted and the whole thing is fixed with a ring. The tool is ready to work. We hope, now you more or less understand how to beat off the braid.