В доме каждого рыболова найдется целая масса items that are suitable for self-manufacturing gear. In the presented material I would like to talk about how to make a spoon from a spoon. The search for an answer to this question will take up further.
How to make spoon-swayer spoon?In the process of studying this issue before the master opens a wide scope for all sorts of experiments, the implementation of original ideas and the manifestation of fantasy. Thus, you can create an unlimited number of gear, each of which will have its own characteristics.
How to make a spoon on a pike from a spoon? This will require the following:
Choosing a teaspoon will allow you to use tackle on the least powerful spinning. Its small size will allow catching fish of a relatively small size: perch, chub, asp.
As for the nature of the metal from whichthe spoon is made, here it is possible to give preference to any alloy, since stainless steel and finishing with silver. Material processing may require a file, a hacksaw, pliers, a hand or an electric drill.
You must first separate the handle of the spoon from itsround part. To do this, use a file, outlining the place where the incision will be made. It is desirable to separate the cuttings of the product with some allowance. This will leave enough space for the breakdown of the holes for the crown rings.
Separating the handle from the spoon is convenient with a hacksawon metal. Having coped with the task, all defects and roughness must be leveled with the help of the same file. The remaining cutting is not recommended to be sent to the scrap. If you wish, you can also make a pretty good long range lure from it. However, let's talk about this later.
Next, you need to make holes on the edgesround part of the workpiece with a drill. To do this, you should select a drill of such a diameter that the crown rings freely enter the holes formed. Before resorting to drilling, it is worth holding the spoon in a vice. If this is not possible, you need to find an assistant who will hold the billet with pliers. Burrs at drilling sites can be removed with a file.
Then it is enough to take a few winding ringsand connect them with the workpiece. It is not recommended to use too small rings. Because they can impede the free movement of gear in the water.
As a hook it is worth using a tee.Its size should correspond to the dimensions of homemade gear. The hook must be connected to the swivel, which should be fixed in the hole on the workpiece with wire.
To increase bait performancebend the spoon handle on the ends. With the help of the same drill in them you need to make holes for fastening the fishing line and hook. The hook is recommended to install on the widest part of the cutting. In this position, homemade spinners will be more like a small fish.
Having figured out how to make a spoon from a spoon, it is worthto think about equipping her tee piece with additional bait. As the latter, you can use a shiny tinsel or a so-called vibrotail. A bright wool thread is also suitable for this.
On the surface of homemade spinners can be designated eye fish. In addition, it is worth painting one side or draw transverse stripes here. All this will increase the number of bites.