/ / How to tie a leash simply? Fastening leashes to the main line

How to tie a leash simply? Fastening leashes to the main line

Among the fishermen,the question of how to tie a leash. He is interested in both beginners and experienced fishermen. Invisibility of the ligament ligament to the felling for fish and strength at the same time is the key to successful fishing. A universal node for this purpose has not yet been invented, but the binding of leashes to the main line is, as a rule, carried out by one of the methods discussed later. But it is only necessary to indicate initially that the ways of fastening the leashes are also applicable to the binding of two lines. Quite often, very complex nodes significantly weaken the line at the binding site. Let's try to deal with the nodes in more detail.

How to tie a leash
Trying to consider how to tie a leash tomain line, you must first identify the most common and not at all difficult method. It is about the simplest fastening of the "loop in the loop." To implement it, the end of the leash from the line with the hook is doubled and tied near the end of the fold by an ordinary knot. Thus, a loop is obtained. The same is done with the end of the main line. If the leash is to be anchored elsewhere, the addition is doubled at this point and tied in a similar way. For control, it is better to tie an additional knot. Then it is necessary to pass the loop of the main forest into the loop of the leash, and the end with the hook to pass into the loop of the main forest. That is, when tightening, a closed clutch is obtained, called the loop in the loop. How to tie the leash in this way figured out, you just need to note that it is better to use it when you need a quick change of leash from a thinner line (with a break, the presence of a ready-made rigging, etc.). Alternatively, for this method, it is advisable to use a swivel on the main line at the bottom gears, this will not only simplify the method of fastening the leashes, but will also reduce the wear of the main forest, considerably reducing the number of hook hooks for the main line. The use of a swivel for more efficient fastening is described below.

Linking leashes to the main line
How to tie a leash to the main forest hard andOnly experienced fishermen know without problems with the swivel. This method is mainly used for bottom fishing. As a basis for binding on the main forest, a swivel is attached. If it is triple, then on both sides it must be tied to the ends of the forest (by any available means). Further, the leash itself is directly attached to the peripheral branch - either by the "loop-to-loop" principle, or simply tied. If this is a simple swivel (double), then through it is passed the main forest, on which it must be fixed with beads. To prevent twisting, the main line in the area of ​​fastening the leash is installed cambric. Directly leash is attached to the swivel. Application of the latter, both in double and triple variations, has good efficiency when fishing. This does not allow the leash to snap once again, and in the case of fish notches, deform the forest. But when catching even large-scale mining, you need to use the smallest swivels (for the purpose of camouflage). This method is well recommended when fastening two segments of the main line, because the swivel does not allow them to twist.

A fairly good effect is the use forfastening the leash. This is a fairly simple device. It is made of a very thin wire, and its purpose is clear from the name. At the end of the wire is a small triangle with a bend, and at a distance of 20-40 cm a small loop is firmly wrapped. How to tie a leash with a tap? Yes, elementary. For this purpose, the same recommendations are used as for attaching any swivel, or the main line is wound around the bend in the triangle of the bend and tightened.

The simplest way to bind a leashis a mount with a knot. The leash is not in principle as such. On the main forest several nodes fix a loop, one end of which is cut off near the node. Directly to the end is attached a hook (mormyshka). This leash, as a rule, has a length of not more than a dozen centimeters. It has little strength, and the probability of breaking the leash and the main forest is 50%. However, they are not entangled, and all tackle has a greater sensitivity, which is necessary when catching small fishes in winter.

How to tie a leash to the main line
Thus, it can be concluded that in order toor a different kind of fishing it is advisable to use a specially selected type of fastening the leash to the main line. There are a lot of ways, they are detailed in fishing literature and online.

Liked:
0
Popular Posts
Spiritual development
Food
yup