Summer fishing on a float fishing rod from the shore insome places are often difficult due to dense vegetation. It is sometimes impossible to throw a tackle exactly into the "window" or to the line of delineation of open water and plants. This is where the fishing rod comes to the aid of fishermen with a side nod and a mormish. A long rod, the absence of a float clinging to algae, as well as a clear signaling about the bite is not all of its advantages.
In this article, we will consider where and how to apply the side nod, as well as how to independently make a tackle for summer fishing on mormyshku.
In the view of most fishermen fishing formormyshku - occupation is exclusively winter, after all, the essence of such fishing lies in the correct wiring of the bait. It is almost impossible to carry out such a procedure with a long summer rod. But in reality, there is nothing complicated in this. It is enough to have a long and light rod, which you can hold in your hands for a long time, a set of mormys, as well as a quality nod that not only signals the bite, but also plays along with the bait.
Conventional fishing rods for summer fishing, equipped withfloat, do not allow fishing in places densely overgrown with aquatic plants, especially when it comes to throwing a long distance. Even if the rig and sinks to the bottom, the float is sure to get stuck or catch.
A fishing pole with a side nod is a different matter.The long rod allows you to “snap” the equipment to the right place, the mormysk drops to the bottom without any problems, and the nod helps it to play with the slightest wiggle of the form.
Catch on a similar tackle on the rivers with weakcurrent, as well as in stagnant water. As for the place, then fishing on the summer side nod can be anywhere, both from the shore and from the boat. In the latter case, of course, a long rod is not required.
This tackle is great for fishing in koryazhnik and in places where there are flooded trees. It is also suitable for fishing off a cliff for hunting such a cautious fish as a chub.
Fishing with mormyshkom summer can be on any fish inincluding on predatory. If this is the usual jigger with a supplement in the form of moldy worm, bloodworm or caddis, roach, crucian carp, perch, and even zander can take it. With the use of unwipless, you can safely count on a bite of chub, roach, crucian carp, carp, the same perch.
Choosing a rod, start with the material of hismanufacturing, because here one of the main factors is the weight of the form. The smaller it is, the more comfortable the fishing will be. It is best to use carbon fiber for these purposes. The mass of the longest rod of this material does not exceed 350 g
Now about the design.Fishing on the side nod in the summer involves the use of a telescopic form. No plug or solid fishing rods are used here. As for the length of the form, it should be at least 5 meters.
Pay attention to the system. More suitable rods fast down with a long hard whip.
No special coil requirements for this.there is no kind of fishing. Some anglers use the reel in general, but for large fish such as bream or crucian carp, it is better to use a zero-speed fishing trip. Take some inexpensive proprietary model with a spool size of 2500-3000 that has a friction brake.
As the main fishing line is suitable as monofilament and braid. The recommended thickness for the thread - 0.2 mm, for the cord - 0.15 mm. At least 30 meters of fishing line should be wound on the reel.
But to the nod requirements are the most stringent, because fromit depends the whole success of fishing. It must have sufficient elasticity to signal even the most careful poklevkah, as well as a certain elasticity, clearly corresponding to the weight of the mormyshka.
As for its size, it should be proportional to the rod: the bigger it is, the longer the nod should be. For example, for a 6-meter blank, 20 cm long stalls would be ideal.
And one more mandatory requirement - it must be clearly visible due to the bright color, which contrasts with the color of the environment.
Side nod for summer fishing rod can be purchasedin a fishing store, and you can make it yourself. It is only necessary to determine which bait it will work with. Ideally, if it is without load it will be straight and bend at an angle of 90 degrees under the weight of the mormyshka. To carry out such tests, of course, you need after its manufacture.
The easiest side nod can be made fromordinary plastic bottle. To do this, choose a bottle of the desired length and cut a longitudinal blank of 20x0.7 cm in size from it. Next, narrow one end of this strip to 0.3-0.5 mm and treat with fine sandpaper at the cut points to remove burrs. Now we take a thin clip and form a loop with two ends that are brought together. This will be our terminal "tulip". We fasten this loop to the narrow end of the future nod with threads and cover the joint with waterproof glue. The end of the nod is recommended to be painted in red or orange so that it is better visible. This can be done with ordinary nail polish.
A denser nod can be made from the oldor a broken telescopic fishing rod for summer fishing. To do this, detach one of the thinnest knees and cut a strip of the indicated sizes out of it. Adjust its width to a certain weight of the jib. At the end of the gatehouse, attach a loop of paper clip, as indicated above. Color the end in one of the bright colors (red, yellow, orange).
More difficult for mormyshke neednod. It is best to make it from thin sheet springy steel. But where to get it, you ask? A good side nod comes from the usual building roulette. Here, even the length does not have to measure - be guided by the existing scale. Scissors for metal cut the workpiece with the dimensions specified above, and carefully process it with sandpaper. The width of the strip can be made less, because the density has become much higher than plastic. Test nod, attaching to the thin end of the line with mormyshkoy. If, under her weight, the gatehouse bends, then you are on the right track.
After sanding, attach a loop of paper clip to the thin end and paint it in a bright color.
Теперь, когда с конструкцией кивка разобрались, it remains to determine how to fix it on the vertex. The easiest way is to attach it to the whip perpendicularly and wind it with threads, filling the connection with waterproof glue. But this method is absolutely inconvenient, as it will cause problems when transporting the rod. Consider several alternatives.
You can take a piece of rubber insulation, whichused for sizing doors and windows. At its core, it is a thin elastic hose with a rectangular cross-section. Cut a piece of seal 3-4 cm long, put it on the tip of the rod. If he does not sit down tightly, we wind the tape under him.
После этого в верхней части уплотнителя с помощью Using a scalpel or knife with a sharp and thin blade, we make horizontal incisions 0.5-0.8 cm long. We insert our guards into them, orienting its end in the right direction.
If there is no "tulip" on the tip of the rod, insteadSealer can use the tube from the dropper or any other similar tube. If the whip is equipped with a “tulip”, take a cocktail tube, cut a 3-4 cm long piece from it and insert it into the hole between the ring and the tip. We nod a nod into the phone and get almost ready gear.
Fishing on the side nod in the summer will be effective only in the case of a successful selection of bait. Here the main role is played by four factors:
Choosing mormyshki, keep in mind that summer modelsa little more winter, so do not need to be shy size, unless it is not about catching on the course with the use of tungsten models. But, since our type of fishing is not used for a strong current, we confine ourselves to mormyshkas from lead and its alloys.
For ordinary lures, we omit the description of the form, since they, for the most part, have round or oval shapes. For them, the main thing is not the appearance, but what is on the hook.
But for summer mormyshek-unwiped shape and color - decisive factors. During this period of the year, you need to focus on the natural diet of fish, because summer is not the most hungry time for it.
Summer fishing on the side nod bream and roach willmore effective when using unwrapped red, orange and yellow colors, as well as their combinations with black. For the chub dark colors are more suitable: brown, gray, black.
The carp on the side nod will react better if the bait still contains bait of animal origin, therefore, it is preferable to use ordinary mormys to catch it.
With regards to the bait form definitely say somethingit is impossible, because in summer all fish is very picky. It is good if you have a set of summer mormysk at hand, including both conventional bait fishing models and a variety of unwrapped ones: devils, ants, goats, drops, uralks, etc.
If there is a universal gear forfishing in the summer, it is a summer jig. The side nod allows you to fish from the shore, and enjoy it, and from the boat. Catching fun is considered the most difficult, as it requires endurance and patience from the angler. Besides the fact that you need to stand in the water, constantly keep a long rod in your hands, you must also try to carry out the correct wiring. Fishing from the shore is a little simpler, at least here you can spread out your gear and bait.
The easiest way to fish from a boat:and it’s easier to choose a suitable place, and there’s no need for a long rod. For such fishing you will need a short form (1.5-2 m) with a quick tip with a fast tip. All other requirements for gear are the same as for a long fishing rod with a side nod.
For summer fishing on the boat there are several types of entries:
With conventional vertical wiring, the riggingput in the right place with the rod. Then it is slowly lowered to the bottom. Lifting the jig is carried out with light vertical movements directed upwards, with a pause of 1-2 seconds every 10-15 cm. After that, the equipment is returned to the bottom again and the process is repeated.
Вертикальная проводка внатяжку по большей части carried out in the presence of a small flow. That it helps mormyshk produce vibrations that attract fish. To do this, the equipment is sent to the bottom, after which it is slowly lifted to a distance of 7-10 cm, and so held for 5-10 s, after which the procedure is repeated.
When playing with your fingers, a similar process occurs.however, during the ascent, the angler additionally “excites” the bait with small strokes of his fingers along the fishing line, departing from the reel or reel, pulling up and releasing it.
Jerking wiring is that mormyshkudown to the bottom in two stages: first to half, after a few seconds completely. After that, make a sharp rise of 30-40 cm up, followed by a repetition of the cycle.
Bottom horizontal wiring impliesoscillations mormyshki along the bottom surface at a distance of 10-15 cm from him, carried out by small-amplitude twitching of the rod in a horizontal plane.
Dragging the bait along the bottom is only possible onopen from aquatic plants territory of the reservoir. Mormyshka lowered to the bottom, after which the rod slowly led away to the side, dragging the bait on the bottom surface.
Passive wiring is intended for lazyanglers who do not want to contribute to the game mormyshki Here you can apply two options: lower the bait to the bottom, so that it simply lies there, or in the half of the bait - so that it can sway over a gentle flow.
The given recommendations concerning the choicemormyshkas, methods and techniques of fishing, can not be mandatory. Any fishing is a kind of experiment in which the angler, even the most experienced, gets a certain experience, which will be useful to him the next time.
So do not hesitate to experiment with bait and fishing technique. Only in this way can you comprehend all the secrets of this fascinating activity called “fishing”.
