Of course, film cameras do not currently enjoy popularity. But connoisseurs of professional work done, for example, with a grain of film, always store a film SLR.
The Zenit-ET camera became one of the mostpopular from the line of DSLRs, released in those old Soviet times. Consider the apparatus Zenith-ET, the instruction of which will help in its productive use.
In fact, Zenit-ET is the same Zenith-10 and -11, but this only applies to the technical side. Outwardly they are noticeably different.
A huge plus of this mirror apparatusis to automatically rewind the film at its end, as well as in the possibility of changing the lens, suitable in size, with a thread M42x1. The equipment was manufactured with two lenses: Helios-44-2 and Industar-50-2, which were the most popular at that time.
So, let's go directly to the instruction.
Zenith ET. SLR camera instruction
First of all, of course,charging the film to the camera. In this action there is nothing complicated. The device has a latch, pulling which you can open the back part, which should be the culprit of this procedure. On the left side you will see a place for the film. However, before you insert it into the socket, pull the tape measure to rewind. Having enclosed the film, release the tape measure and pull the protruding edge to the coil on the right so that it "looks" inside the camera. Close the camera cover, then cock the shutter, lowering the lever to the end. Press the button to take a picture, and then (in order for the device to feed an unlit film), cock and release the shutter twice.
We set the exposure. Using the exposure scale, we connect the arrows of the exposure meter and the calculator. Stop on the scale of 250, then the aperture should show the number 4.
This means that if the aperture is at 8, then the scale will show 60, so we set the shutter speed to 1 / 60s.
It is also desirable to study GOST-ASA DIN for photosensitivity of exposure.
It can be installed with a disk by rotating ituntil complete fixation. The aperture is set according to the depth of field. Turn the ring until it snaps into place and set the proper aperture number. The distance scale will help to select a certain depth of field in accordance with the selected aperture.
Having studied once a good Zenith-ET, the instruction of its modifications will then seem to you an example for second-graders. Now you can start a full shot.
You can take a picture with the whole family, notleaving no one behind the scenes. This can even make a film camera Zenit-ET. The instruction attached to it completely describes this method. Let's just say that it takes 7 seconds for the self-timer.
Also, the camera is shooting fromflash, which works automatically in sync with the shutter. A big plus is that the flash is portable and will not interfere with you when shooting, because in itself Zenit-ET weighs about one kilogram. There are two ways to install the flash. The first is the rod contact in cage 10, and, of course, the plug socket. Therefore, you can use a wired flash, for example, in a photo studio, or portable, which is convenient to use anywhere. The main thing is not to break this convenience with "dead" batteries.
If you have a similar camera, thenbe sure to treat it carefully, exclude the possibility of direct rays of sunlight falling into the camera lens. Be careful that dust does not penetrate it, because cleaning will be very painstaking, when as a daily rub is the best solution.
Camera Zenit-ET, whose instructions are clear to the true photographer of photography, will help to master the basics of photography for the beginner.
