A car starter is a device,It is designed to start the engine by rotating its crankshaft. At the heart of its design is a conventional electric DC motor, which is controlled by the driver from the car's interior.
The starter does not have a permanent connection withcrankshaft of the power unit. They interact only a few seconds at start-up due to a special relay. About him, we'll talk in this article on the example of "Samara" fourteenth model. We will try to figure out what the VAZ-2114 starter relay is, where this device is located, how it works. We will also review the main malfunctions and the procedure for replacing it.
Let's start with the location of the device.At the "fourteenth" it is placed on top of the body of the launch device. In fact, these two nodes are combined into one, although they are completely different devices. In front, they are covered by a common lid, under which is the mechanism that connects them.
Some drivers tend to think thatVAZ-2114 starter relay is a separate element that serves to protect the electrical circuit of the starter. In fact, everything is not so. Indeed, individual owners of cars, incl. and "fourteenth", install an additional circuit breaker in the starter circuit. But he has nothing to do with the device we are considering.
The VAZ-2114 starter relay consists of:
On different modifications of VAZ-2114 can bedifferent starter circuit breakers are installed. Some of them are collapsible, others are not. The first, in case of their malfunction, you can try to repair, and the last - only to replace.
Relay trigger is often calledretractor. This is due to the principle of its work. As well as on other cars, on VAZ-2114 the relay of a starter carries out function of connection of the starting device to an electric chain and connection of its anchor with a cranked shaft. There is it as follows. When the current is not applied to the windings of the device, its armature, under the action of the return spring, is in the forwarded position. This same spring, through a special fork, holds the bendix gear, preventing it from engaging with the crown of the crankshaft flywheel.
Turning the key in the ignition switch, we supply currenton the winding of the device. Under the influence of the electromagnetic field, the armature is fed back (retracted into the body), closing the starter power contacts. The gear wheel of the bendix moves, too, engaging with the flywheel. At the same time, the retractor winding is turned off, and the retainer enters the case. The force from the starter shaft is transmitted through the gear to the flywheel, causing the crankshaft to rotate until we stop holding the key in the ignition lock in the start position.
Understand that the VAZ-2114 relay starter failed, you can by such features:
The retractor may lose its functionality due to:
Before judging the malfunction of the starter relay,it must be checked. It is recommended to start with the wiring. For verification, we need a multimeter, included in the voltmeter mode, and an assistant. The positive probe of the device is connected to the positive terminal of the disconnecting device, the negative to the mass. Next, ask the assistant to turn on the ignition and start the starter. We take the voltmeter readings. If the device shows a voltage of 12 V or more - with the battery and wiring, everything is in order. If it is lower, the battery may be low.
Now let's check the status of the contact "pyatakov".We disconnect from the relay a wire proceeding from the ignition lock. With the help of a large screwdriver we close the output of the device connected to the battery and the terminal connecting it to the starter. In this way, we apply voltage directly to the starter. The starting device has worked - the problem is exactly in the relay. It remains to decide whether to repair it or change it.
As already mentioned, the relay on the "fourteenth"can be non-collapsible and collapsible. In the first case, there is nothing to guess - you need to buy a new device. If it is collapsible, you can try to repair it. However, hand-repair can be justified only in case of burning or oxidation of contact "pyatakov". It is not advisable to rewind windings or to change internal parts of the device.
How much will it cost to buy a new relay? Believe me, it's cheaper than repairing it. The cost of a standard domestic device is about 700 rubles. You can buy and import retractor relay starter VAZ-2114. Price on foreign analogues begins with 800 rubles.
As for the performance of repair work, hereyou will have to choose. If you have enough experience with a hand tool and a couple of hours of free time, you can also manage yourself. If you do not want to bother with this, please contact the auto service center. There you an maximum of an hour without problems will install a new starter relay VAZ-2114. The price for such work is about 800 rubles. Expensive? Then roll up your sleeves!
Replacing the retractor relay starter VAZ-2114 implies the use of the following tools:
Replacement of the starter relay VAZ-2114 is carried out in this order:
In order for the retractor to serve as long as possible, listen to these tips: