How is the putty of the walls for wallpaper?

Without gluing the walls with wallpaper, you can not even imaginenot a single repair. To ensure that the results of your work are optimal, you need to know how to make the putty walls for the wallpaper. It will achieve a perfectly flat surface of the walls, which will ensure a tight fit of the finishing material and significantly improve the appearance of your house.

What is necessary for the work?

It is necessary to buy a primer of a deeppenetration, as well as the shpatlevku. The latter is produced not only in dry, but also ready for use form. In addition, you will need a regular roller of foam rubber, a spatula and sandpaper, without which the finish finish will be incomplete. After the preparation of all consumable materials and tools, the puttying of the walls for the wallpaper begins.

Methods of work

First of all, you need as carefully as possibleremove old wallpaper. Saturate the old wall cover with water, and if necessary, steam it with an iron. It is necessary to bring the old paper to such a condition that it can easily be pushed with a spatula and torn off.

To putty the walls under the wallpaper was easier,the spatula needs to work from the bottom up, since in this case there is less risk of damage to the surface itself. Given that it is better to rip off a damp coating, do not hesitate: as if moistening a large area, you should try to remove the wallpaper from it in one go.

Before the beginning of the direct finishing you mustHow to treat the surface with a primer and allow it to dry a little. If there are large irregularities, large cracks and other serious defects, you need to plaster them. After waiting for the plaster to dry, sand the surface and apply the primer again. And now begins the putty walls for the wallpaper.

First, apply the base layer.If you use a powder version, then you need to dilute the putty, following the instructions exactly. Experts say that the easiest way to start work from the top of the wall.

Taking a small spatula, scoop out of the containera small amount of putty and place it on a larger tool. Applying it to the wall, apply the putty with an economical and smooth movement, directed from left to right. Moving your arm in the opposite direction, remove excess material. Given the cost of putty walls for wallpaper from good manufacturers (about 1050 rubles for 15 liters), it will allow you to save a lot.

Remember that the material must be applied in such a way thatits layers found each other. At a time, do not try to cover most of the wall, since you simply smear the putty without achieving a normal result.

At the very floor of the technique of applying severaldiffers from the above. Move the spatula only from the bottom up, and the movements are the same as when applying the putty itself, and when removing its excess.

After carrying out all basic works, the wall must be dried. Using abrasive paper, all rough surface defects should be completely removed.

At the end, the finishing putty of the walls for wallpaper (the price of the material varies from 300 rubles per three liters). It will remove even the smallest cracks and irregularities.