Motobur Champion AG252 is aquite light and compact device, inside of which a high-performance, powerful engine is installed. He usually helps to solve household tasks in the country, in the garden and out of town, when there is a need to engage in fishing in the winter. Its cost is not so high in comparison with analogues. That's why the model is popular. To ensure long-term operation, you should read the rules of use and storage of the instrument, which will be described below.
With the help of a powerful motor, the unit performs workon drilling holes in the ground for planting plants and installing poles for fence. This tool was developed to solve problems in areas where the use of heavy equipment is impossible. The equipment is used for public purposes. When installing a special drill perfectly copes with the preparation of holes on the ice. The unit has found its application when it is necessary to quickly plant plants in the garden. It is noteworthy that the Champion AG252 is delivered complete with a drill on the ground, the dimensions of which are 200x500 mm.
Capacity of equipment, which is equal to 1.46kilowatt, is sufficient to ensure stable operation even at the highest loads. The manufacturer has taken care of the availability of an excellently regulated ignition system, which facilitates a quick and easy start. As practice shows, the air filter can easily be extracted, which prevents its contamination and significantly extends the service life. The connecting rod of the product and the motor shaft are manufactured by the manufacturer of high-strength steel, which contributes to the maximum possible strength of the device.
Motobur Champion AG252 has a diaphragmcarburetor. It provides stable operation in any position. Overheating of the engine is impossible, because the air cooling system is installed inside. If you have high density soil on the site, a strong gearbox and gear ratio (40: 1) will provide easy operation. The device is designed in such a way that the controls are located very conveniently. The whole design is ergonomic, so the master can easily perform the adjustment of the operating mode even with one hand. As additional advantages it is necessary to allocate presence of an antivibration system and a low noise level, that raises comfort at work.
Motobur Champion AG252 you can buy for 11600 rubles. Its power is 1,460 watts, and in horsepower this figure is two. The working volume is equivalent to 51.7 cubic centimeters. The maximum diameter of the drill is 250 millimeters. Only one operator can use the unit. Before purchasing you should be interested in such characteristics as tank volume, weight and type of cartridge. Let's talk about them in detail. For example, 0.98 liters will fit into the tank. The weight of the device is equivalent to 5.9 kilograms, and the cartridge has a length of 20 millimeters. For one minute, the working part of the tool makes 2800 revolutions.
Motobur for poles of the brand "Champion"provides for the presence of an engine assembly, as well as gloves and tanks for the preparation of fuel mixtures. You do not have to purchase a set of keys, glasses and a repair kit that comes with the kit. In the packed form, the goods weigh 9.2 kg. And its dimensions are 590x350x400 millimeters. The homeland of the brand is the United States. However, the country of origin is China.
Pobbin for pillars from the company Champion haspush-pull single-cylinder engine. This equipment, according to users, is covered by the warranty for 1 year, which is given by the manufacturer. The device is included in the line of budget gardening equipment. It is widely used in construction, communal, agricultural and other household activities. As users emphasize, the device is equipped with a fuel tank, which is filled with a mixture of gasoline and oil in a certain proportion. Among the additional advantages, according to customers, budget, high quality of assembly and applied materials, as well as low weight.
Motobur for fishing must refuelfuel-oil mixture. For its preparation, unleaded gasoline with an octane rating of 92 should be used. It is mixed with a motor oil designed for two-stroke engines. In this case, use the ratio of the first ingredient to the second in a proportion of 50 to 1. Never pour oil, which is intended for two-stroke engines with water cooling. It is inadmissible to use liquid, which is used for two-stroke engines having low maximum revolutions. Not suitable for this equipment and oil for four-stroke engines.
The motobur for fishing will work properly ifyou will correctly prepare a fuel-oil mixture and store it under certain conditions. To do this, use special metal containers or products made of non-food plastic. The mixture should be prepared in a well-ventilated area or outdoors. It is forbidden to prepare it in the tank of the device. In the container should pour half of the prepared gasoline, add the necessary amount of engine oil, close the lid tightly and mix the fuel mixture.
The lid is opened, which will allowto let out the air. Then you should top up the remaining gasoline, close the container and again make a thorough mixing. Before refueling the fuel tank, you must shake the liquid in the container. It needs to be used up within 30 days after the preparation. With prolonged storage, the composition is oxidized and becomes non-uniform. Never fill in clean gasoline to refuel the tool.
Champion AG252, reviews about which you will read inarticle will not be repaired under warranty in the event of a breakdown. For example, if the engine fails during operation with an improperly prepared fuel-oil mixture. Do not store the unit with fuel in the tank indoors, as the vapors of the mixture are explosive. The engine should not be run over and leave for a long time at idle. It will reach maximum power only after producing 10 full fuel tank fillings.
The Champion AG252 must be exempted fromhousing every 25 hours of operation. During the same period, a filter is removed, which is washed in gasoline and dried before re-installation. The quality screw will allow you to adjust the ratio of fuel and oil at maximum engine load. Its adjustment is carried out on the tachometer. The screw, which is indicated by the letter L in the instruction, will allow you to set the engine running at idle. This will ensure excellent idling stability. It is important to remember that a high position and weather conditions can affect the operation of the carburetor. If you purchased the AG252 Champion equipment, the instruction before you start using the instrument should be studied by you. From it you can find out that the fuel filter needs to be periodically checked. If it is heavily soiled, it should be replaced.
Dirty filter can cause start up difficultyand a decrease in motor performance. It is important to clean the cylinder fins with a brush or compressed air, since contamination of this element can lead to overheating of the engine. It is important to check the drill, honing it or replacing it if necessary. Parts for the Champion AG252, in particular the replaceable tip and the non-replaceable knife, can be purchased from the manufacturer. Periodically, it is necessary to check the condition of the blades and repair them. This also applies to the bit tip.
Before long storage it is necessary to clearequipment and lubricate metal parts. The fuel should be drained from the tank and the lid closed. The candle must be removed. The stator cord must be pulled several times, which will allow cranking and cranking the oil. Then the candle is put in place. The engine should be wrapped in a plastic bag, and the motobur itself should be stored in a dry place, preferably away from heat sources.
If the engine does not start, the faultcan consist in the wetting of the spark plug or the presence of a gap. In some cases, insulation is damaged. When the candles are wetted, they should be cleaned and dried, and if there is a gap, set it to a mark of 0.6 millimeters. If the distance between the rotor and the stator is too long, it should be adjusted to 0.4 millimeters.
Sometimes the problem is insufficient powerengine, and the cause may be the penetration of air into the fuel pipe connection. If it is in the carburetor connection, then tighten or change the gasket. Stopping the motor during the operation of the equipment can talk about a damaged piston or bad magneto. In the first case, you should replace or repair the piston, but in the second - the state of the spare parts. If there is water in the fuel, you should get rid of it by filling the tank with a new mixture.
Motobur Motobur Champion AG252, a screw for whichyou can purchase at a cost within 1000 rubles. Can work with interruptions, expressed in the absence of rotation when the engine is running. This problem is indicated by the damaged clutch or failure of a fixed fit between the output shaft and crankshaft. In both cases, the relevant parts must be replaced.
