In the modern technological world, repairvarious units and assemblies is becoming increasingly popular. The bulkhead of the engine is a rather complex process, which, besides the skill, also requires good theoretical training. In order to quickly and effectively eliminate the breakdown, it is necessary to conduct a thorough analysis and assessment of the condition of the unit, and here, of course, not without dispensing with diagnostics.
It is the very first stage beforethe engine bulkhead will start. Its price is low, it depends on the brand of your car. The whole procedure is carried out using a special scanner that connects to the car's on-board computer and allows you to see not only the general characteristics, but also the errors that occurred during the engine operation. Only after that they establish the concrete cause of the breakdown, and the engine bulkhead begins. However, it should be noted that such diagnostics will not show little defects or future breakdown. The engine bulkhead of VAZ models rarely includes diagnostics, since the onboard computer is completely absent on some of them. In this case, the complete dismantling of the unit is carried out, after which the defective parts are revealed and fixed, which are recorded in a special document.
Standard diagnostics, before the engine bulkhead starts, includes:
- Compression measurement in each cylinder;
- Exhaust gas and technical liquids are being studied;
- The general technical condition of all components, parts and assemblies of vehicles is checked;
- The pressure level in the cooling and lubrication systems is determined;
- Check for extraneous sounds.
After the diagnosis
A budget is prepared for the details and work on theinstallation. If the customer agrees, then the engine bulkhead begins. It is important to note that every detail included in the estimate should be discussed with the client individually, should explain the expediency of this replacement and obtain permission from the client for this operation. The full cycle from acceptance of the car to the service station before issuance to the owner from the professionals takes from 3 to 5 days. Of course, there are cases when the cost of work and the number of parts increases with complete disassembly. This is normal practice, because some machines are not yet so computerized to show breakage of some small parts or their heavy wear. Be aware that in this case you should also be notified before the repair begins, to voice the cost of the part and work. If the account for the engine bulkhead is higher than the previously declared cost, then you have the right to demand evidence of the expediency of these actions, as well as the provision of old parts that have been replaced with new ones.
Never save on such repairs, choosetested and specialized centers. For a 10-15% overpaid, you will not only get a qualified service, but also significantly increase the life of the engine of your car, and do not rise again for repairs several thousand kilometers away.
