To date, install the roof on the houseis not such a complicated undertaking. The roof of the house with your own hands is a less expensive type of work, but without the help of a small team of people, work can take a long time. The roof for the house is one of the most important components, since without it no master will feel completely safe before the climate tests. That is why many owners think correctly how to build the roof of the house. In this article, it is planned to highlight the general principle of work on the production of a saddle roof.
To ensure that the roof of the house with their own hands wasdurable and meets all safety rules, you must first design its frame on paper, and only then start the installation. For the construction of the roof, we need to buy a bar with the typical dimensions of 50x150x6 in the required quantity. This bar is calculated based on the fact that the placement of these bars will occur on the roof every 60 cm.
Since our roof will be one-sided, then oneFrom the supporting walls of the house it is necessary to install vertical standing sections from the bar for the installation of the bearing beams themselves. Each of these vertical segments must be fixed to the wall using self-tapping screws, approximate length of each of 9cm. Before installing and securing the beams, it is necessary to check the vertical level and drill holes in vertical racks at an angle. The height of vertical racks is calculated based on the projected angle of the roof of the house.
The hardest thing is for the roof of the house to have its ownhands was correctly installed is the process of lifting the wall of the house 6-meter long bars. For this work you will need a team of 3-5 people, as one is simply not physically able to do it. One of the ends of a 6-meter beam should be fixed to a vertical support, reinforced with the help of self-tapping screws. The second end is best placed in the cutout in the wall at a distance of 5 cm deep. After that, this end is also fastened with screws.
One of the most important points is the problemwith a horizontal laying of single-bearing beams, which will give the ceiling a perfectly even execution. This problem is solved with the help of a universal building level and a 5-meter rope. The process of horizontal laying of beams is as follows:
1) To begin with, a single-support beam with one endmust be supported in the wall, and the second end, previously tied with a rope, is attached to the already installed beam. Then, on the beam to be installed from above, we must put the level.
2) By attenuating the rope gradually we reach the position where the beam begins to assume an absolutely horizontal position. After leveling the beam, we tighten it into a knot on the rope.
3) Attach the beam to the beam.To do this, it is best to choose the following method of joining: we fasten the beams by fastening the two beams through and through the places where they are fastened together. For fastening it is best to use studs with a diameter of up to 10 mm, as well as washers and nuts, which are connected together.
After the roof of the house with his own hands is almostfinished, it is necessary to tackle the felling of the pediment. This small space between the wall and the roof is best clogged with boards with a thickness of 20 mm, and can be fastened to vertical racks with nails or bolts with nuts.
Thus, all the work on the correct installationroof and roof you will not take more than 3-4 days. I hope that after this article the question of how to make the roof of the house, you no longer worry. If there are any questions, please contact the personal mail on the site.
