Sealing rubber for the refrigerator: features of selection and replacement

First you need to figure out whyNeed a sealing gum for the refrigerator. The most basic function of this element is to ensure the tightness of the unit chamber. Naturally, the gum should be of the highest quality, otherwise, in addition to the excess build-up of snow, you can get a breakdown of this household appliances. To date, such a seal can be of different types. In any case, it will be one- or two-ball.

Sealing rubber for the fridge shouldhold tight on the device door. The easiest way to mount is the "herringbone", which provides for the insertion of the element into a special groove from which it can be quickly reached while washing the refrigerator. Moreover, there is no need to use additional glue-based products.

Sealing rubber for the refrigerator canbolted to the base with screws. However, this method is very risky, as it can damage the door. At the same time you can lose the tightness that you are trying to achieve. The production also uses the adhesive method of fastening seals. Its only drawback is that when replaced it will be quite difficult for you to dismantle it.

It should be noted that the sealing rubber forRefrigerator should be selected according to the model of the appliance. Otherwise, the element simply does not fit, quickly deforms and cracks. Properly mounted seal will last much longer. However, if it is still spoiled, then you need to install a new element.

Replacing the rubber seal on the refrigeratorimplies a certain sequence of work. First you need to remove the door from the hinges and put it in, since it is extremely difficult to do all the procedures in a vertical position. Old rubber should be carefully separated from the base. For this, you may have to trim it slightly. During the removal of the old seal try to work as carefully as possible, so as not to damage the groove on which it is fixed. In work you can use a small spatula.

The place where the gum was installedsealing for the door of the refrigerator, should be well cleaned from the zapinivatel. Then with the help of a hard thorn it is necessary to fix the new element. If you could not find a suitable sealant, you can use the one that exists, however, you will have to cut it exactly in accordance with the dimensions of the door, and fix the joints with glue. Moreover, the substance should not be afraid of negative temperature.

If all steps were performed exactly withinstruction and quality, the work will take no more than 1 hour, and your refrigerator will work like a new one. However, if you are afraid to perform this procedure yourself, you can call a specialist to the house. That's all the features of replacing the old seal. Good luck!