In order to form a new decorativecovering the walls, you must first get rid of the old. Vinyl wallpaper could be used as a finishing material. Before you begin to remove them, you need to familiarize yourself with what constitutes this material. The main positive feature of its features is the possibility of washing the walls.
Vinyl wallpaper can be issued on non-wovenor paper based. The structure of the material is similar to the cake, the upper layer of which consists of vinyl, the second - of porous plastic, while the bottom layer is the base. This structure allows you to hide the irregularities of the walls, which should be considered when applying a new finish. After all, it may require leveling the surface, sealing cracks and chips.
If you have a question about how to removeVinyl wallpaper from the walls, you should know that they are classified into two varieties. The first is represented by a material resistant to mechanical stress, while the second is a coating that is resistant to moisture.
If you wondered how to removevinyl wallpaper from the walls, then you first need to clean the room, if possible for this are taken out pieces of furniture, and those that are too overall, covered with a film. The floor can be covered with plastic and newspapers so as not to slide on the surface during the work.
На выходе из комнаты укладывается мокрая ветошь, so as not to spread dust throughout the house. In order to eliminate accidents, it is necessary to turn off the electricity, whereas lighting devices should be removed from the walls. As for switches and sockets, the wallpaper under them should also be removed. To do this, unscrew the screws, and the wallpaper is torn off, after the switches can be installed again in place.
If you have wondered how to remove vinyl wallpaper from the wall, then you will need to stock up on a certain set of tools, among them:
When choosing a roller, you should prefer the one thathas thorns, it is also called wallpaper tiger. The bucket will need to be filled with warm water, adding dishwashing detergent. This will allow in a short time to remove the wallpaper. Foam sponge can be replaced with a spray or roller with a pile. In order to prevent damage to the outlets, they are usually sealed with masking tape; after doing the work, it can be removed quite easily.
Quite often homeworkers wonderon how to remove vinyl wallpaper from the walls. When it comes to the usual paper surface, it will be quite easy to remove it. For this, the surface is only moistened with water and left for some time to soak. After that, the material can be cleaned from the walls with a spatula or scraper.
But if on the walls of the room vinyl wallpaper, thenthey may have moisture resistance properties. However, you can still use water to remove them. In the first case, use a spiked roller. If it was not possible to purchase it, you can use a metal brush or a regular knife, however, such tools are less convenient to use.
Wallpapers have a multi-layer structure, sowhen you remove them, you can save the wall without damaging it. Using one of the above tools, it is necessary to perforate the top layer of the coating. As soon as it was possible to do this, the wallpaper must be wetted with water You can add impurities to it, such as dishwashing detergent or a special liquid.
Quite often, the owners of apartments and houses are setthe question of how to remove vinyl wallpaper from the walls quickly. Do not neglect the recommendation about the need to add special solutions to the water. In this case, the composition, on which the wallpapering was carried out, will dissolve easier and faster.
For wetting the surface can be used.spray gun or ordinary rag. However, do not use water in an excessively large amount, as you can damage the walls and flooring. Once the material is saturated, you can proceed to the removal. Better to move bottom-up. Any remaining material should be removed with a spatula.
If the finish does not give in, then you need it again.moisten with water, it should be done as the surface dries. In some cases, the craftsmen decide to leave a layer of vinyl wallpaper on the wall, this is true in the case when the finish is quite tight.
If during repairs you are also faced with the question ofHow to remove old vinyl wallpaper from the wall, you can resort to an alternative solution - it's time to use. However, for this it will be necessary to find a steam generator, the simplest solution would be an iron, which has a steam function. This method can be applied only after the perforation of the protective decorative layer, only after you can proceed to the surface treatment with steam.
Under its influence the glue will begin to swell,therefore, the wallpaper will rather quickly be deleted. By resorting to this method, you not only clean the walls quickly, but also without dirt. To supplement the impact of steam on the wall can be wet rags. In this case, the walls are heated by an iron through a soaked rag. The effect will be the same as the steam.
If you have a question about how easyremove the vinyl wallpaper from the walls, then you can consider another technology that involves the use of wallpaper glue. In the water they add not only it, but also a special liquid for removing vinyl wallpaper. This method is relevant when the old finish does not want to move away from the walls. The resulting composition should be treated surface and leave for a couple of hours.
After the wallpaper can be removed in solid stripes.You can remove the coating with a metal brush, sandpaper or a sander. These methods, however, are more time consuming. It is necessary to use them with maximum accuracy, because there is a possibility of damage to the walls.
Quite often beginner home masterswondering how to properly remove vinyl wallpaper from the walls. Such a task can also be set up in the case when wallpaper was stuck onto plasterboard sheets. This material is quite poorly coped with exposure to moisture.
Even if you used moisture resistantdrywall, then excessive moisture for it can be traumatic. Old wallpaper in this case must be removed very carefully. Their top layer is perforated and moistened with water. It is better to use special tools. The technology remains the same as when using water, but in this case its volume should be significantly reduced.
It’s a long time to decide how to remove vinylWallpaper from the wall is not necessary if the surface was previously covered with a putty. Therefore, before starting repairs, you need to take care of this. Wallpaper on non-woven base in some cases, you can exfoliate, removing only the top layer, which does not pass moisture. To do this, the edge must be pushed with a spatula or a knife, but the base in this case is removed by maceration. If PVA glue was used to glue the wallpaper, then it is unlikely to succeed in maintaining the integrity of the plasterboard.
In order to easily cope with work onremoving the old decorative coating, which no longer looks, as before, it is necessary to begin to determine on what basis the wallpaper was created. In addition, it is not necessary to immediately wet the entire surface of the walls, it is necessary to process only small areas. Otherwise, the wetted material will quickly dry, and the work will need to be carried out again. When dealing with this issue is no longer better. It is necessary to moisten abundantly, but you should not overdo it. This rule especially applies to plasterboard walls.
Removing vinyl wallpaper from walls is nottoo challenging. However, sometimes it turns out to be monotonous and time consuming. In order to quickly begin to enjoy the new repair, it is necessary to remove all things from the room and cover heavy items of furniture with polyethylene or newspapers. We should not forget about security, for this electricity is turned off. Simplify the task of using special liquids, their acquisition should be taken care of in advance.
