VAZ-2114 is the second generation of the legendary LadaSamara. " The machine got a new look, but did not get rid of the old problems. In particular, these are regular problems of the salon heater. It often happens that the VAZ-2114 oven blows cold air on the sides and on the windshield. Naturally, this problem should be addressed urgently before the onset of the first cold weather. So, let's look at why on the VAZ-2114 the stove is blowing cold air and how to solve this problem.
This is a kind of valve that forcescoolant to move in a large or small circle. It serves to quickly warm up the engine. But this part is also connected with the salon heater. While the thermostat does not open on the "big circle", the stove will be cold.
Это вторая причина, по которой на ВАЗ-2114 печка blowing cold air. Also because of this problem, the motor itself can overheat. Where in the system can be air? The reason is an unauthorized "suction", which may occur during repair operations of the system. So, very often air gets when replacing the same thermostat or the heater's cock. How can I check for it in the system? First you should pay attention to the temperature sensor. But not always it gives an accurate result. The machine can also operate in normal mode, but at the same time there will be air in the radiator of the stove. How to identify it? It is enough to touch the rubber pipes that go to the heat exchanger. At VAZ-2114 they are on the right, on the passenger side. In total in the stove system there are two branch pipes.
The solution to the problem is quite simple.It is necessary to drive up the hill with the front part of the car. The higher the degree of recovery, the better. Further on the working motor, unscrew the plug from the expansion tank and wait until all the air leaves the system. According to the laws of physics, air is lighter than liquid and tends to go up. So we will create the most favorable conditions for this. Enough three to five minutes of the engine to completely remove the plug from the system. Periodically, it should be podgazovyvat up to 2-3 thousand revolutions, in order to create more pressure for the coolant (the more the crankshaft rotates, the more often the pump rotates). It is also recommended to squeeze and unclamp the inflated nipple - so we will speed up the process of discharging oxygen to the outside. But be careful - the temperature can reach 90 degrees. For safety reasons, wear gloves.
This is another reason why the VAZ-2114The stove is blowing cold air at the feet and not only. The damper may not fit securely for several reasons. So, the control lever may come off or flake foam. In the latter case, you need to paste a new one. Preferably for high-quality glue.
You can see the picture of the side dams below.
If the VAZ-2114 oven blows cold aireven after tightening the cable, it is worth to inspect the state of the lever itself, which opens the flap. Despite the thickness of the metal, it can crack. In this case, the damper klinit in one place. Usually it is slightly ajar. As a result, air from there blows a completely different temperature. The way out is to buy a new lever.
So, we found out for what reasons the VAZ-2114The stove is blowing cold air. As you can see, the problems can be different. But before buying new parts, you need to accurately determine the essence of the problem. Probably, the blame for everything is an airlock. In the case of a cable, it is not necessary to change it entirely. Above is presented a way how to resume its operability by a simple pull-up. But whatever reason arose, in any case, it can be solved by oneself with minimal expenditure.
