Understand the question: "How to connect two computers to the local network?"

Sometimes users who have a couple at homecomputers or a computer and a laptop, want to establish a network between them to transfer files from one device to another without resorting to the help of media. And then the question arises: "How to connect two computers to the local network?" This can be done through a direct connection.

It is worth noting that if everything is done by oneself, then this iswill be quite difficult. You can make a cable that connects computers, yourself, or buy it in a shop already ready. Suppose that you bought the cable, that is, you do not need to bother with it. When deciding how to connect two computers to a local network, it should be noted that the cable should be connected directly to both devices. If there is a special indicator on the Ethernet controller, it should glow green and sometimes flash. In the case where the indicators do not light up, or only light at one end, you should check the quality of the cable crimp and the absence of mechanical damage there. It is also necessary to check the availability of special drivers for the controllers on the computer, and also to make sure that the hardware is installed correctly.

Settings

We continue to understand the issue of "how to connecttwo computers to the local network. "Now we need to go to the process of setting the parameters in the operating system itself by opening the control panel and finding the option of network connections.In the already present connections, find the" Connection over the local network. "You must open the properties of this point by clicking on the right button of the manipulator.In the window that appears, you need to find the "Internet Protocol", then again invoke the properties.

In order for you to get a local network of twocomputers, it is necessary for each of them to assign a specific network address, which will allow to identify it. Typically, the IP address is written in the standard format: E.F.G.H, where letters correspond to numbers from the range 0-255 for each. You have the ability to select absolutely any number, however it is recommended to set up addresses within 192.168.0.1-192.168.0.254. It is important to remember that the last number should not be the same on the connected computers, otherwise an identification error will occur. It will be most correct to choose addresses sequentially, so it will be easier for you to navigate. In all three windows, click "OK". On the second computer, you must perform similar manipulations, remembering what should be its network address.

If we talk about how to properly connectlocal network, then after all operations, double-click the "Local Area Connection" label, after which the status window will appear before you. With the correct setup, you will see a message about the presence of the connection. If an error was made during the configuration process, the connection will be restricted.

Now you know how to connect twocomputer to the local network, so go ahead. The next step is to allow shared folders. This is done so that you have the ability to move files between computers. To do this, you need to right-click on any folder or disk, and select "Sharing and Security" in the pop-up menu. In order to make the folder accessible to the second computer, you must tick the appropriate item. Everything, the folder is accessible for work from other computer.