How to glue carbon film on the car: process features

Carbon is great todaydecoration for the car. In addition, the material helps to protect the surface from minor damage (scratches). Carbon film on the hood, as well as on other parts of the machine, consists of carbon filaments, which are glued together in a special way. A feature of the presented material is a small mass with high strength. The disadvantage is its cost, so not everyone can afford this luxury, although it will subsequently fully pay off.

If you do not know how to gluecarbon film, first deal with the color, type of material, as well as the place where you are going to mount it. It should be noted that to issue in this way, and some internal parts of the car. Work should be done as carefully as possible. It is impossible to hurry in this matter, since you can spoil the rather expensive material. Sticking surface must be flat. In addition, it is easy to make a mistake in the choice, since it is rather difficult to distinguish the original material from the fake. However, in any case, he is able to close the small scratches on your car.

Before you glue the carbon film,Try to pre-select the necessary material. No specific tools needed. Prepare the film itself, the building dryer, and also clean the area of ​​the machine that will be treated from dust.

Before you glue the carbon film,Be sure to degrease the surface with isopropyl or other alcohol. If there are any irregularities on the machine, they must be eliminated. To do this, you can use priming substance (primer). Large areas that will be processed with a film should be preheated so that the material adheres better. Small details do not need this procedure.

So now you can go directly tosticking. Before you properly glue the carbon film, it is imperative to cut an element that will exactly fit the surface to be processed in size and shape. However, please note that at the edges of the hood, doors or trunk should be cut material with a margin, as these elements of the car are very often used. Note that the temperature of the air in the room or outside should not be less than 5 degrees Celsius.

Since the material has a substrate, then remove itfollows only after careful adjustment of the item. Now wash the treated area with soapy water so that no air bubbles form under the material. In addition, in this case, you can position the element as accurately as possible. Now we glue the carbon film with our own hands: remove the substrate, place and adjust the material on the surface, smooth it with a rubber squeegee and heat it with a building dryer. Note that the element should be smoothed from the middle to the edges. The film is straightened very carefully.

After the entire element is pasted,re-walk on it with a hairdryer and leave alone for a quarter of an hour. After that, iron the surface with a felt squeegee, cut off the remnants of the material and enjoy the beauty of your car.